SEE Tracker Entries

Vibrator track looks to be bent up in multiple spots. Tarp roller travel on track could easily fall off.

Stress light on and nobody’s stressing

The bay 2 trough and floor is getting bad. See picture for the water trough

While picking a piece with a John Deere part, the device started to pull out/off the piece as we were in the rotating process. Since this device was installed in the yard, we are unaware of the embedment depth, amount of epoxy, and whether or not the holes were cleaned out well enough prior to applying the epoxy. None the less, this piece (WSS-3250) only weighted 23k we were able to get the piece vertical. May want to look into this a little more.

B5 pieces set on the floor are sitting on long 2x4s which are warped and sticking up approx 6" off the floor causing a tripping hazard

Tripping hazard by tb1

Trucker took belts off of load before being in place to pick with crane

Load not tied down

The yellow plastic panels above the beamline break room were flopping in the wind yesterday. they potentially could break off and fall to ground. I will put req in to attach boards similar to the rest of the building

An extension code is being used to power the new overhead door in plant 1

While conducting a tornado drill, employees struggled to hear the community sirens and some folks didn't take shelter quickly.

Tornado horns not functioning low batteries, and three went missing.

Driver Robert Ebert was the last load onsite. Load 73 with10 Plank on the load. They were unloading deck plank on steep hill leading into basement. The crane operator picked 2 pieces of plank and started to raise the load off of the trailer. Because of the incline, the end of the load closest to the crane lifts off the trailer before the front end. The stack was dragged for a bit until it is completely off the trailer. As the load clears the trailer, the truck starts to slide down the incline. The driver hollered for the crane operator to put the weight down onto the trailer. he did but it continued to slide until the trailer made contact with the crane hitting the step. There were no injuries to personnel. When the load was lifted off the trailer, it pulled the truck suspension up taking most all of the weight from the truck allowing it to slide.