SEE Tracker Entries

There is a portable table saw and some vacuums in front of the fire extinguisher and eye wash station.

Cage builders aren't using cage gloves and could potentially get cut

We have a tire fell off on a standup trailer 8062 today. Heard there was another trailer did this not long ago. Didn't know until a few days later last month. see picture

Ay en todas partes de afuera junto ha las ares de trabajos

Employee operating the overhead crane with a grout bucket almost hit the forklift as it drove by.

while cutting lifting eyes in high wind some sparks blew over to a concrete blanket. quite a ways away and melted the blanket

The brackets that hold up the screed board and other things on each bed are bolted through the expanded metal. I think the bolts should be through the angle iron for a stronger support.
On the FS22, one of the bolts is almost pulled through the expanded metal.

Trailer 8095 wheel fell off. See pictures. This Been happening a lot if i knew about this every time. I will put it in

Tracy Roberts was moving sides on the B5. After setting down and bolting in the last side on the west side of the form, he unhooked the south crane and tried to raise it up and move it out of the way. He had the wrong remote in his hand and was raising the north crane which was still hooked up to the form. The crane let loose and broke the safety brake on the cable.

Jim spoke to yellow hat on east end of Orange bed before walking past the bed. The yellow hat did not communicate that the bed was in the middle of stressing.

Door (guard) over the top of mixer 2 discharge was completely removed for easier cleaning.

7 inch grainger set on vise press

Red hat for the Beam line was grinding without a face shield