SEE Tracker Entries

Trash pile was swept up but left on the floor causing a trip hazard.

Employees had the side ports on the air wand taped off.

I have seen a lot of good insulation put in the dumpster that could be used for different size recesses rather than using new sheets of insulation for that. I think there would be significant saving over time.

A 275 gallon tote of what we believe is Rapid 1 is sitting outside batch plant 2. This is a bad storage area because it is in close proximity to a drain.

Concrete being dribbled on the road from the beds to the batch plant.

A Welder was cutting material with no PPE on at all.

The operator was getting ready to use the torch and the hose connector had a hole in it near the hand and lower arm area. When the torch was lighted the leak area also ignited causing the outer garment to start on fire

el chuk de batidora de ormogon tenia mucho ormigon pegado del hotro biaje

Upon my arrival at work, I was notified by Rick that Glen Baumann had inadvertently backed into the shot blaster control cabinet with the forklift. The plastic control cover was broke into several pieces. We have since fashioned a temporary cover from sheet steel while we try to source a replacement. Everything else is still mechanically sound.

Brett called me out to look at a DT in row-3, the deck was broken due to incorrect dunnage placement, this piece was set here within the last couple of nights. when they stacked the T on top they did not line up the T blocks with the stems and the weight of the T caused the bottom piece to crack.

Cutting without flaggers

The ground at DT staging is very unstable.

Coming out of the maintenance area, the band saw was running and no one in the area